Can I use the same Lightburn program to run two laser engraving machines?
December 11, 2025Are you running multiple fiber lasers on a breaker? What size breaker are you using? Is running 2 okay for a 220 with a plug converted to 120? Or is it okay to run 2 lasers on standard 120 plug?
December 12, 2025I have one EZCad2 artwork file that will not engrave with any power. Has worked fine in the past.
M:
Issue is with the File, it’s been corrupted. Best is to Import in the Original Artwork, FYI resizing Graphics in EZ2 changes the Line Width of the Hatch as well. You must Click Off and Ban On a hit Apply in the Side Bar to Reprogram the Hatch after resizing.
G:
Before I saw this response I ended up deleting the hatch and ungrouping the lines while in the defective file, THEN copying the artwork over to a good file and regrouping and re-hatching. Seemed to fix it. Thanks!
